Go Back   Cigar Forums > Cigar Forums > Cigar Humidors


Reply
 
LinkBack Thread Tools Display Modes
Old 09-25-2011, 11:26 AM   #101
Senior Member
 
rmrdaddy's Avatar
 
Join Date: Apr 2006
Location: South Jersey
Posts: 1,364
I think Barco is on the right track here. You are using an analog gauge as a basis for your actual RH and I have frankly NEVER seen an accurate analog gauge. In 20 years, never seen one be accurate.
Get the digital, salt test it, write down your variances, stick them ON the unit, and relax a little. We have all been there, when the cigar hobby first begins to consume your life (not kidding!), you want to micromanage EVERYTHING. Don't worry, we will help you
__________________
A brave man likes the feel of nature upon his face, but a wise man knows enough to come in from the rain...


Accomplish Nothing....\=-----=/
rmrdaddy is offline   Reply With Quote
Old 02-23-2015, 11:58 PM   #102
Member
 
Join Date: Feb 2015
Location: Jackson TN USA
Posts: 31
Originally Posted by beinwalt View Post
I am going to have to face the facts though that my humidor simply isn't any good and buy a new one at some point.
I'm assuming you have a fairly typical wooden desktop-box humidor.

Don't give up on it just yet! You might have a leak at a joint, but more likely you have a leaky seal where the lid meets the body of the box; the sealing lip is probably part of the humidor's Spanish cedar liner, and it shrinks slightly when it gets too dry (very common in most places during winter). There are a couple of possible fixes that I found on the Internet.

The first one is very simple. All you need is a small paintbrush and some of the same 50/50 mixture of propylene glycol and distilled water that's used in florist's-foam humidifiers. "Paint" the lip of the humidor all the way around and let it soak into the wood. The distilled water will cause the Spanish cedar lip to swell slightly, and the propylene glycol will help the wood hold moisture longer than it would by itself. You might try this two or three times over consecutive days if necessary, until the wood swells enough to slow or stop the drop in relative humidity. If this works well enough, you might find that the seal stays good for a few days at a time; when the wood shrinks again, just apply more distilled water to the lip.

The second requires only a little more work. For this you will need a roll of blue painter's tape -- I use the version of Scotch Blue Painter's Tape that has low-medium adhesion and is designed for delicate surfaces -- and a very sharp knife or single edge razor blade. You will need to let the sealing lip dry again, which shouldn't take more than a few hours if your home's air is dry. Cover the entire lip with a layer of tape all the way around, carefully trimming the tape at the corners so there are no gaps and no overlap. You want a single layer of tape covering the entire sealing lip.

If neither of these do the trick and the humidor is still leaking badly, I suggest you find a new use for it. Perhaps it can become a "junk box" for holding odds and ends, or a "treasure chest" for the kids/grandkids.
CamoSutra is offline   Reply With Quote
Old 01-25-2018, 07:57 AM   #103
adg
Junior Member
 
Join Date: Jan 2018
Location: Brooklyn
Posts: 1
Hello!

I have a humidor that I seasoned accidentally with filtered water (thinking it was the same as distilled). I have been unimpressed with the quality of my cigars in there.

I use a 69% boveda and have no hygrometer.

I am afraid my seasoning mistake is the cause.

Can I fix it or should i invest in a new one?

Thanks
adg is offline   Reply With Quote
Reply

  Cigar Forums > Cigar Forums > Cigar Humidors

Tags
humidor



Thread Tools
Display Modes